Instruction Manual

Page 2 of 3
MAGNETIC DIMMABLE DRIVER INSTALLATION GUIDE
System Diagrams
The following diagrams are provided as example system designs. Use the Orange Boost Tap (see ‘Boost Tap’) as an oponal voltage boost in place
of the Black (Line) wire if the xture is receiving noceable light degradaon (200W & 300W models only). Cap the exisng hot wire not in use. See
‘Boost Tap’ on previous page. Install in accordance with the NEC and local regulaons.
L = Line (Black)
N = Neutral (White)
GND = Ground (Green)
V+ = Low Voltage Positive
V- = Low Voltage Negative
MLV Dimmer Diagram
3-Way MLV Dimmer Diagram
† Install a compable magnec low voltage dimmer switch. See dimmer switch manufacturer installaon guide for complete wiring instrucons.
†† Dimmable drivers require a compable magnec low voltage dimmer switch to supply the driver and xture with appropriate input voltage.
Do not test or install directly connected to an AC power source or On/O switch. It is recommended to load the driver no more than 80% its
labeled rang for maximum longevity. See dimmer switch manufacturer specicaons for minimum load recommendaons.
‡‡ See xture specicaons for maximum series run limits.
AC Power
50/60Hz
120VAC Magnetic Low
Voltage Dimmer
†
V+ (Red)
V- (Blue)
LED Strip Light / Fixture
‡‡
LN
N (White)
L (Black)
Magnetic
Dimmable Driver
††
Install applicable wire gauge / type
V+
V-
V+
V-
GND (Green)
AC Power
50/60Hz
Traveling
Lines
3-Way On/Off Switch
120VAC Magnetic Low
Voltage Dimmer
†
Magnetic
Dimmable Driver
††
V+ (Red)
V- (Blue)
N (White)
L (Black)
V+
V-
V+
V-
Install applicable wire gauge / type
LED Strip Light / Fixture
‡‡
LN
GND (Green)