User manual

DAG Series User Manual

Dinstar Technologies Co., Ltd.

4. Port Config

This page is used to config the account and password of DAG serial, call transfer, call waiting and

do-not-disturb service. Port 0 maps to FXS0, while Port n maps to FXS n.

Figure 3-3-13 Port Config

Table 3-3-6 Port Config

Current Port

Select configure a SIP trunk port

TX/RX Gain

Handset volume adjustment. RX is for receiving volume, TX is

for transmission volume. Default values are -6dB for both

parameters. Loudest volume: +6dB Lowest volume: -6dB.

Offhook Auto-Dial

Fill in the number of offhook auto-dial

Enable DND

Default is No. When enabled all incoming calls are rejected.

Enable Caller-ID

Default is Yes

SIP User ID

SIP count number

Authenticate ID

SIP user name which registers to soft switch/SIP server

Authenticate password

SIP password which registers to soft switch/SIP server

Call Forwarding Unconditional

All incoming calls are transferred appointed phone.

Call Forwarding Busy

Call will transfer appointed phone when Busy.

Call Forwarding No Reply

Call will transfer appointed phone when nobody answer the

call.

Disable Call Waiting

Default is No. User can use * code to use this feature per call

basis.

Disable Call Waiting Tone

Default is No. Indicates an incoming call，default is 2 short

beeps.