User manual

DAG Series User Manual
14
Dinstar Technologies Co., Ltd.
3.3.1 System Information
Figure 3-3-2 System Information
System information interface shows the run information and port group information.
Table 3-3-1 Description of System Information
MAC address
The device ID in HEX format. This is needed for ISP
troubleshooting. Note there are separate MAC addresses for the
WAN side and the LAN side.
Network Mode
Route mode or bridge mode, if it is bridge, WAN port display
Network, and the WAN port as same as the LAN port
WAN port
Show WAN IP address of equipment,.
DHCP mode:
The equipment acquires its IP address from the first DHCP server it
discovers from the LAN it is connected.
Static IP mode:
Configure the IP address, Subnet Mask, Default Router IP address,
DNS Server 1 (primary), DNS Server 2 (secondary) fields. These
fields are set to zero by default.
LAN port
Show LAN IP address of equipment. If network mode is bridge,
LAN port will no display.
DNS Server
IP addresses of primary DNS server
System Up Duration
Time elapsed from device power on to now.
Network Traffic Statics
Total bytes of message received and sent by network port.
Version Information
Includes: product mode, software version, hardware version and
built time etc.
Port Group Information
Show FXS / FXO port information