User manual

DAG Series User Manual
10
Dinstar Technologies Co., Ltd.
2.5 Call Features
The DAG serial supports all the traditional and advanced telephony features.
Table 5.DAG serial Call Feature Definitions
*47
Direct IP Calling. Dial “*47” + “IP address”. No dial tone is played in the
middle.
*50
Disable Call Waiting(for all subsequent calls)
*51
Enable Call Waiting(for all subsequent calls)
*72
Unconditional Call Forward:
Dial “*72” and then the forwarding number followed by “#”. Wait for
dial tone and hang up. (dial tone indicates successful forward)
*73
Cancel Unconditional Call Forward: To cancel “Unconditional Call
Forward”, dial “*73”, wait for dial tone, and then hang up.
*78
Enable Do Not Disturb(DND): When enabled all incoming calls are
rejected
*79
Disable Do Not Disturb(DND): When disabled, incoming calls are
accepted.
*87
Blind Transfer
*90
Busy Call Forward: Dial “*90” and then forwarding number followed by
“#”.Wait for dial tone then hang up.
*91
Cancel Busy Call Forward. To cancel “Busy Call Forward”, dial
“*91”,wait for dial tone, and then hang up.
*92
No Answer Call Forward. Dial “*92” and then the forwarding number
followed by “#”. Wait for dial tone then hang up.
*93
Cancel No Answer Call Forward. Dial “*93”, wait for dial tone, and then
hang up.
*99
Cancel all call forward
*114#
Report phone No
*158#
Report IP Address
*111#
Reset
Flash/Hook
Toggles between active call and incoming call(call waiting tone). If not in
conversation, flash/hook will switch to a new channel for a new call.
2.6 Sending and Receiving Fax
DAG serial supports fax in two modes: 1) T.38 (Fax over IP) and 2) fax pass through.
T.38 is the preferred method because it is more reliable and works well in most network
conditions. If the service provider supports T.38, please use this method by selecting T.38 as fax
mode (default). If the service provider does not support T.38, pass-through mode may be used. If
you have problems with sending or receiving Fax, toggle the Fax Tone Detection Mode setting.