User manual

DWG2000-16G User Manual
_______________________________________________________________________________
Dinstar Technologies Co., Ltd.
29
4.7 Routing Configuration
4.7.1 Routing Parameter
Figure 4-7-1 Routing Parameter
Table 4-7-1Description of Routing Parameter
Tel->IP Parameter
Globle parameters, it will take effect while number manipulation configured
Route calls after
manipulation
The parameters indicate that the gateway will select Tel->IP routes after
number manipulation completed
Route calls before
manipulation
The parameters indicate that the gateway will select Tel->IP routes before
number manipulation completed
4.7.2 IP->Tel Routing
Figure 4-7-2 IP to Tel Routing
Table 4-7-2 Description of IP to Tel Routing
IP ->Tel Routing
This item uses to configure outgoing call routes which can be used for recieve the
calls from the GSM
Index
It uniquely identifies a route. Its value is assigned globally, ranging from 0 to 31.
The route preferentially match the rules which the value of index is smaller
Description
It describes the route for the ease of identification. Its value is character string
Source IP
It specifies the IP of the caller
Source Prefix
All the caller number must match the source prefix. It specifies the source prefix
allow to send call out
 Any: include anonymous, 0xxxx, 1[2-9]xxxx etc.
 0xxxx: consist of some digits such as 015,08,09
 1[3-8]6:consist of some prefix, include 136,146,156,166,176, 186