User manual

DWG2000-16G User Manual
_______________________________________________________________________________
Dinstar Technologies Co., Ltd.
25
Alarm Threshold
（via SMS）
When the SIM remain time is or less than this value, DWG will send the alarm
SMS to remind the users of the SIM remain time.
Port Description
for Alarm
It is the identification mark of SIM/UIM card in the SMS report. The mobile
phone No. of the SIM/UIM card is recommended to use as the port description
for alarm, or any other string.
SIM Remain
Time
Indicates the current sim remain time. It can’t modified
Restore time
Recovers the SIM remain time to initial value, the Maximum Call Duration.
CLIR
Caller ID display restrict. This function is used to restrict the mobile phone
No. By adding “#31#” before the mobile phone ID, this funciton should be
supported by carrier.
Mobile Tx Gain
Transits gain of the mobile module, from IP side to PSTN side.
Mobile Rx Gain
Receives gain of the mobile module,from PSTN side to IP side.
Detect Reverse
Polarity
This option for CMDA Reverse Polarity detection. Most CDMA operators
don't offer polarity reverse . So VoIP to mobile, DWG2000-16G will connect
soon. It doesn't wait mobile side answer.
4.6.3 SIM/UIM Card Lock
Figure 4-6-3 Configuration of SIM/UIM Card Lock
Table 4-6-3 Description of Configuration of SIM/UIM Card Lock
Select Port
Select the Channel No. which need to be locked.
SIM Card Lock
SIM card lock or unlock. Default is “No”.
PIN Code
Correct PIN code is needed to lock or unlock the SIM card.