User manual

DWG2000-16G User Manual

_______________________________________________________________________________

Dinstar Technologies Co., Ltd.

3. Network Configuration

In this chapter we will introduce the initial configuration of DWG2000-16G. All of the network

parameters of the gateway can be configured by IVR guidance.

3.1 Attentions

In each step, if user hears an IVR message of “setting successful”, which means that user has

finished this step successfully. However, if user hears a “setting failed” message, please check

redo theat step again.

3.2 General Feature Codes for System Setting

Table 3-3-1 Feature codes for system setting

Dial numbers

Features

*114#

Play the phone NO.

*115#

Check the TT number of gateway (using just when the device interconnects

with other series of DINSTAR products)

*150*a#

Set IP address(static/DHCP), a can be digit 1 or 2,*150*1# is static IP

address mode, *150*2# is DHCP mode

*152*a*b*c*d

Configure IP address, a, b, c, d are the four fields of IP address.

*153*a*b*c*d

Configure subnet mask. a, b, c, d are the four fields of the subnet mask

*156*a*b*c*d

Configure the device gateway, a, b, c, d are the four fields of the device

gateway

*158#

Report the IP address

*157

Setting the work mode (route or bridge), * 157 * 0 # is route mode, * 157 *

1 # is bridge mode

*195#

Play record

*198#

Clear record

*199#

Setting Record. dial*199# start record(≤ 20s), then press # end the

recording

*111#

Restart device