User manual

DWG2000-16G User Manual
_______________________________________________________________________________
Dinstar Technologies Co., Ltd.
11
3. Network Configuration
In this chapter we will introduce the initial configuration of DWG2000-16G. All of the network
parameters of the gateway can be configured by IVR guidance.
3.1 Attentions
In each step, if user hears an IVR message of “setting successful”, which means that user has
finished this step successfully. However, if user hears a “setting failed” message, please check
redo theat step again.
3.2 General Feature Codes for System Setting
Table 3-3-1 Feature codes for system setting
Dial numbers
Features
*114#
Play the phone NO.
*115#
Check the TT number of gateway (using just when the device interconnects
with other series of DINSTAR products)
*150*a#
Set IP address(static/DHCP), a can be digit 1 or 2,*150*1# is static IP
address mode, *150*2# is DHCP mode
*152*a*b*c*d
#
Configure IP address, a, b, c, d are the four fields of IP address.
*153*a*b*c*d
#
Configure subnet mask. a, b, c, d are the four fields of the subnet mask
*156*a*b*c*d
#
Configure the device gateway, a, b, c, d are the four fields of the device
gateway
*158#
Report the IP address
*157
Setting the work mode (route or bridge), * 157 * 0 # is route mode, * 157 *
1 # is bridge mode
*195#
Play record
*198#
Clear record
*199#
Setting Record. dial*199# start record(≤ 20s), then press # end the
recording
*111#
Restart device
VoIPon www.voipon.co.uk [e-mail] Tel: [phone] Fax: [phone]