User manual

DWG2000-1G User Manual
_______________________________________________________________________________
Dinstar Technologies Co., Ltd.
44
Internet terminal Channel. This information is used for two host to set up
UDP communication behind the same NAT router. The agreement
defined by the RFC 3489
CLID Mode
Select the name under the special needs , the most common way is use the
default User ID
Allow Outgoing Calls
without Registration
Refer to "SIP Configuration" -> "Is register" . If "Is register" setting is no,
this option need set Yes ,to avoid that the devices can not call out
Allow Incoming Calls
without Registration
Refer to "SIP Configuration" -> "Is register" . If "Is register" setting is no,
this option need set Yes ,to avoid that the devices can not call in
Allow Anonymous
Outgoing Calls
The incoming anonymous calls will be rejected
Use # as End Key
In General, SIP phones are based on # as the end, if this option is set to
No, the dial-up will end expires dial-up time
Inter digit Timeout
Bit of between the dialing time ,over the time will be seem as end of dial
4.11.3 SIP Configuration
Figure 4-11-3 SIP Configuration
VoIPon www.voipon.co.uk [e-mail] Tel: [phone] Fax: [phone]