User manual

DWG2000-1G User Manual
_______________________________________________________________________________
Dinstar Technologies Co., Ltd.
17
Table 4-5-1 Description of Local network
Work Mode
Two options of route mode and bridge mode, default is bridge mode
Link Speed & Duplex
The 5 options are “Auto Detect”,” 10Mbps/Half
Duplex”,”10Mbps/Full Duplex”, “100Mbps/Half Duplex” and
“100Mbps/Full Duplex”. Default is “Auto Detect”
Obtain IP Address
Automatically
Enable the device obtain IP Address automatically or not. Default is
enabling
Use the Following IP
Address
Configure the "IP Address", "Subnet Mask" and "Default Gateway"
by manual
PPPoE
Need ISP offer the account and password. Use this mode when have
not router in the local network.
Obtain DNS Server
Address Automatically
When enable the WAN port option of "Obtain DNS Server Address
Automatically" , which will be enabled subsequently.
Use the Following DNS
Server Addresses
Fill in the IP address of "Primary DNS Server" and "Secondary DNS
Server"
WAN /LAN Port
WAN port used for connecting the external network , LAN port used
for connecting local network
4.5.2 MAC Clone
Figure4-5-5 Configuration of Mac Address Clone
This function can prevent the device against blocking by the carriers. Enable this function on the
“router mode”, the device can be anti-blocked when the carrier to limit the online users by
scanning the MAC address.
VoIPon www.voipon.co.uk [e-mail] Tel: [phone] Fax: [phone]