User's Manual

Operating Instructions
Installation & Notice
1. Working principle
The transmitter sends trigger signal to main panel paired when the magnet mounted near is moved apart.
2. Pairing with main panel
Scanning the QR Code for Pairing.
①
Scan the QR code on this accessory.
②
The pairing result would be conrmed on App.
Hint: How to trigger
①
Remove the battery insulating sheet.
②
Move the magnet around transmitter until the red LED indicator lights up.
• Pull out the battery insulative strip.
• Pairing to main panel by App before installing.
• Attach the transmitter and magnet seperately on door/window and its frame with double-side sticky tape or x with screws.
• Make sure the distance between transmitter and magnet is less than 1cm and at the same level.
• Avoid installing the sensors in area with a large amount of metal or electric wire.
Features
Parameters
Appearance
The wireless contact sensor is an accessory of smart alarm system.
It's fashion design, energy saving, and low battery warning supported. The system would inform users to replace the battery
by App when needed. And it will also send users alert of opening doors/windows when system is arming or home arming.
It's easy to setup and works well with most doors and windows. When transmitter and magnet are apart, the sensor triggers
alarm.
• Working Voltage DC 3V
• Battery 1 × CR2032 button battery (3V)
• Working Current
≤
40mA
• Standby Current
≤
2μA
• Transmission Distance Up to 300m without obstacle
• Transmission Frequency 433.92MHz
• Working Temperature -10
℃
~50
℃
• Humidity ≤90%rh (non-condensing)
• Weight 35.5g(battery included)
• Dimension
Transmitter: 80.0mm*38.2mm*13.3mm
Magnet: 80.0mm*14.8*12.9mm (L*W*H)
LED Indication
Magnet
Transmitter
LED flashes once: Door/window is opened and transmitter sends signal to the main panel.
The LED indicator will light up every 1 second in the event of low battery. Please replace the battery in time. Push
notification will be sent to your APP.
LED Indicator
Tamper Detector
Less than 1cm
Entry Delay & Home Arm Settings
This product features ‘Entry Delay,’ ‘Home Arm’ and ‘Ready to arm’ modes and can be selected in App.
Entry Delay feature : Under Arm/Home Arm mode, in the event the sensor is triggered, the system will wait for preset time then
set o the alarm.
Home Arm feature : Under Home Arm mode, when the sensor with this feature is enabled and triggered , the alarm will be set
o.
Ready to arm feature: Under Arm or Home Arm mode, system will send you push notications in the event any door/window
is not closed.