Service Manual

MAINTENANCE

 WARNING: Disconnect power and allow heater to cool

before attempting any maintenance or cleaning to reduce

the risk of re, electric shock or damage to persons.

NOTE: The replace should not be operated with an

accumulation of dust or dirt on or in the unit, as this can

cause a build up of heat and eventual damage. For this

reason the heater must be inspected regularly, depending

upon conditions and at least at yearly intervals.

Partially Reective Glass Cleaning

The partially reective glass is cleaned in the factory dur-

ing the assembly operation. During shipment, installation,

handling, etc., the partially reective glass may collect dust

particles; these can be removed by dusting lightly with a

clean dry cloth.

To remove ngerprints or other marks, the partially reec-

tive glass can be cleaned with a damp cloth. The partially

reective glass should be completely dried with a lint free

cloth to prevent water spots. To prevent scratching, do not

use abrasive cleaners.

Fireplace Surface Cleaning

Use only a damp cloth to clean painted surfaces of the

replace. Do not use abrasive cleaners.

Servicing

Except for installation and cleaning described in this manu-

al, an authorized service representative should perform any

other servicing.