Operating Guide

22 www.dimplex.com
Operation
J. Sleep Timer
The Sleep Timer can be set to
automatically shut o󰀨 the replace
after a preset time (from 30
minutes to 8 hours).
To set the timer press the
timer button on the remote,
repeatedly, until the desired
time is displayed.
The Display will display the
di󰀨erent times as it is adjusted.
Once the timer has begun,
pressing the
button will
display the time remaining
before the unit turns O󰀨.
!
NOTE: The Sleep Timer can
be cancelled at any time
by pressing the button
repeatedly until the sleep timer
displays nothing.
Control Lockout
Pressing the T- and Brightness
buttons at the same time and
holding them for 2 seconds will lock
(LOC will be displayed) or unlock
(U L will be displayed) the manual
controls on the replace.
Resetting the Temperature
Cuto󰀨 Switch
Should the heater overheat, an
automatic cut out will turn the
whole unit o󰀨 and it will not come
back on without being reset. If the
button on the unit is pressed,
Er2 will be displayed on the unit.
It can be reset by turning the unit
o󰀨 at the main disconnect panel
and waiting 5 minutes before
turning the unit back on.
CAUTION: If you need to
continuously reset the heater,
turn the unit o󰀨 at the main
disconnect panel and call
technical support at:
1-888-346-7539.
U