Service and Repairs

15
12. Ensure that all wires are replaced in the same manner
as prior to the service.
13. Reassemble in the reverse order as above.
Upper Access
Cover
Flicker Assembly Replacement
Tools required: Phillips head screwdriver
Wire cutters
1. Follow “Preparation for Service” instructions before
proceeding.
2. Remove the plastic media tray by removing the 4
screws: 2 on the left and 2 on the right of the tray.
(Figure 7)
3. Lift the plastic media tray out of the unit.
4. Remove the front panel by removing the 6 screws: 3 on
the left and 3 on the right of the tray.
5. Remove the 17 screws along the top of the ame panel
and gently remove. (Figure 6)
6. Gently pull the motor away from the icker rod.
CAUTION: When removing and replacing the icker
motor try to keep any slight bending of the icker rod
minimal so as to not damage it. If icker rod is dam-
aged, it should be replaced to ensure proper operation.
7. Ensure that all wires are replaced in the same manner
as prior to the service.
8. Reassemble in the reverse order as above.
Flicker Motor Replacement
Tools required: Phillips head screwdriver
Short handled Phillips head screwdriver
1. Follow “Preparation for Service” instructions before
proceeding.
2. Remove the plastic media tray by removing the 4
screws: 2 on the left and 2 on the right of the tray.
(Figure 7)
3. Lift the plastic media tray out of the unit.
4. Remove the front panel by removing the 6 screws: 3 on
the left and 3 on the right of the tray.
5. Remove the upper access cover located on the bottom
right hand side by removing the screws securing it to
the unit.
6. Remove the left most ame panel (gure 6), the 2 verti-
cal screws on the right hand side of the center ame
panel may need to be removed to easily pull the left
ame panel out.
7. Remove the icker motor mounting bracket from the
unit.
Flicker
Motor
Lower Access
Cover
Lens
8. Remove the 2 screws holding the icker motor to the
mounting bracket. Gently pull the motor away from the
icker rod.
9. Remove the 2 screws holding the icker motor to the
mounting bracket. Gently pull the motor away from the
icker rod.
10. Trace the wiring up to the main control board and re-
place with new wires.
11. Properly orient the new icker motor onto the motor
bracket and re-attach with the 2 mounting screws.
CAUTION: When removing and replacing the icker
motor try to keep any slight bending of the icker rod
minimal so as to not damage it. If icker rod is dam-
aged, it should be replaced to ensure proper operation.
12. Reassemble in the reverse order as above.
Thermistor Replacement
Tools required: Phillips head screwdriver
1. Follow “Preparation for Service” instructions before
proceeding.
2. Locate the thermistor attached to the bracket in the
upper left hand side of the unit.
3. Remove the thermistor by cutting the tie wrap securing
it to the stando󰀨.
4. Follow the cable back to the main control board and
disconnect the old thermistor and connect the new
cable.
5. Rerun the thermistor back to the brack ensuring that
the wiring is replaced in the original locations.
6. Ensure that all wires are replaced in the same manner
as prior to the service.
7. Reassemble in the reverse order as above.
Figure 8
Figure 9