Owners Manual

12 www.dimplex.com
Fireplace Installation (continued)
120V Installation - Plug Kit
WARNING: This heater is
not intended for use with an
extension cord. Plug the cord
directly into an ap propriate
wall receptacle.
To install a plug kit:
1. Locate the rear cover plate
about 12 in. (30.5 cm) from the
left side at the bottom. Remove
the 3 screws that hold the plate
(Figure 8).
2. Feed wire from plug kit into
opening and attached using the
using the 3 screws.
3. Connect the L1 wire from the
unit to the black wire of the plug
kit.
4. Connect the N wire from the
replace to the white wire from
the plug kit.
5. Connect ground wire from the
replace to the green wire from
the plug kit.
6. Ensure that all wire connections
are tight and that wires are
secured and do not protrude
past the ame panel, so as
not to be visible after nal
installation.
7. Continue to nal installation.
Figure 8