Use and Care Manual

Operation

Resetting the Temperature Cutoff Switch

Should the heater overheat, a manual limit cut-out will turn the unit off and it will not come back on without being

reset. If the button on the unit is pressed, Er2 will be displayed on the unit. It can be reset by turning the unit off at

the main disconnect panel and waiting 5 minutes before turning the unit back on.

CAUTION: If you need to continuously reset the heater, turn the unit off at the main disconnect panel and call

technical support at: 1-888-346-7539.

Brightness

Press

repeatedly to cycle through the brightness and icker modes.

Solid H - High Brightness

Solid L - Low Brightness

Cycle H - High Brightness with ickering media

Cycle L - Low Brightness with ickering media

Timer

Press

repeatedly until the desired number of hours of the timer is displayed. When

this function is active, the replace will turn off after a set amount of time. The timer

can be set from 30 minutes to 8 hours in intervals of 30 minutes.

To turn the timer off, press repeatedly until 0 appears on the display.

While the timer is active, press the timer button to see the time remaining.

Factory Reset

Press and hold

and at the same time for 3 seconds to restore the unit to its

factory default settings.