Use and Care Manual

18 www.dimplex.com
Operation
Standby
Press
to turn the unit on or put it in standby mode.
When the unit is turned back on, it will retain the previously used settings.
Flame Effect
Press
to turn the ame effect on or off.
Heat
Press
to turn the heat on or off.
The replace can be operated in heat only mode by turning off the ame and color
effects.
Heat Disable
Press and hold
and at the same time for 3 seconds to disable or enable the heat
function. This action must be performed on the hidden touch controls.
When the heat is disabled and either the , , or is pressed, --- will appear on the
display.
Thermostat
Control
Press
or to adjust the temperature setting of the thermostat.
When the temperature setting is adjusted, the set temperature will ash for 2 seconds,
then the ambient room temperature will be displayed briey.
The temperature can be set from 5°C to 37°C (41°F to 99°F).
Temperature
Display
(°C ↔ °F)
Press and hold
and at the same time for 3 seconds. This action must be
performed on the hidden touch controls.
Eco Mode
Press
to activate Eco mode. In Eco Mode, the heater runs at reduced power to
save energy.
Heat Boost
Press
to activate Heat Boost and adjust the duration by 5 minute increments,
up to 20 minutes. In Heat Boost, the heater runs at maximum power to quickly
heat the space.
Themes
Press
repeatedly to cycle through the 8 different Themes:
1 - White
2 - White with orange accents
3 - White with blue accents
4 - Red
5 - Blue
6 - Prism — media bed cycles through colors
7 - Kaleidoscope— media bed cycles through colors at different rates
8 - Midnight mode — media bed lights are off
Custom Color
Freeze the media lights to a custom color.
When in Prism or Kaleidoscope modes (see Themes), press
while the desired color
is displayed to freeze the cycle on that color.
Press again to resume the color cycle.