Owner's Manual

16 www.dimplex.com
Operation
1. Room Temperature
Displays current ambient tem-
perature in the room.
2. Set Temperature
Displays and controls the heater
to the temperature at which the
thermostat is currently set to.
Press 8 to lower the thermostat
and press 9 to raise the thermo-
stat. Pressing both 8 and 9 to-
gether will toggle between Celsius
and Fahrenheit.
3. Flame Effect Icon
The ame icon will icker if and
when the Flame Effect is turned
on. Press 11 to turn the Flame
Effect on, and press 10 to turn the
Flame Effect off.
4. Purire™Icon
The display arrows for the Puri-
re™will cycle when turned on.
Press 13 to turn the Purire™
function on, and press 12 to turn
Purire™ off.
!
NOTE: The Purire™ function
on this device will control only
those units with the Purire™
installed.
5. Heat Off Indicator
This function manually overrides
the thermostat control and pre-
vents the replace’s heater from
coming on.
To do this, press 8 to decrease
Set Temperature to any tem-
perature below 0
o
C or 32
o
F. To
reactivate heat from “HEAT OFF”
setting, press 9 to increase the
thermostat Set Temperature. The
Set Temperature will be displayed
starting at 21
o
C (70
o
F), replacing
the “HEAT OFF” icon.
6. Function Lock Indicator
Enabling this function will lock out
the Wall Switch Remote Control
so as to prevent the current set-
tings from being changed. To
Enable, press 8, 9, and 10 se-
quentially. To disengage, press 8,
9 and 10 sequentially again. The
Indicator icon will be displayed
when enabled.