OPERATING INSTRUCTION MANUAL Dimplex Opti-myst Electric Stove Models: Willowbrook WLL20-AU These instructions should be read carefully and retained for future use. Note also the information presented on the appliance.
CAUTION: FAILURE TO FOLLOW THESE INSTRUCTIONS AND/OR DAMAGE AND MAY INVALIDATE YOUR GUARANTEE MAY CAUSE INJURY Important Safety Advice When using electrical appliances, basic precautions should always be followed to reduce the risk of fire, electrical shock and injury to persons, including the following: If the appliance is damaged, check with the supplier before installation and operation. Do not use outdoors. Do not use in the immediate surroundings of a bath, shower or swimming pool.
Warning: In order to avoid overheating, do not cover the appliance. Do not place material or garments on the appliance, or obstruct the air circulation around the appliance, for instance by curtains or furniture, as this could cause overheating and a fire risk.
Installation Instructions This heater must be used on an AC ~ supply only and the voltage marked on the heater must correspond to the supply voltage. Before switching on, please read the safety warnings and operating instructions. Please retain this user’s guide for future reference Ensure that all packing items are removed (read any warning labels carefully). Retain all packing for possible future use e.g. in the event of moving or returning the appliance to your supplier. Installing the Appliance; 1.
Operating The Product WARNING: FAILURE TO INJURY AND/OR DAMAGE. FOLLOW THESE OPERATING INSTRUCTIONS MAY RESULT IN Manual Controls The manual controls are located behind the stove door. Open the stove door to access the manual controls. (Fig 2) is the on/standby button. Press it once to turn on the product. Press it again to turn off the product. When turned on a ‘beep’ will sound and the digital display will show followed by the current room temperature. The display will then turn off.
• • • • Press the button to display the current room temperature followed by the current set point temperature Press the and buttons to adjust your set point temperature. Note: if the set point temperature is below the room temperature, the heat function will not operate. The temperature range is from 15 - 35°C Press to increase the setting. Press to decrease the setting. Setting the Thermostat Plug in the product and press to turn it on. Press the button twice and to enter the temperature set mode .
We recommend cleaning the following components once every 2 weeks, particularly in hard water areas: Water Tank, Sump, Nozzle, Tank cap and seal, Air filter. For general cleaning use a soft clean duster – never use abrasive cleaners. To remove any accumulation of dust or fluff, the soft brush attachment of a vacuum cleaner should occasionally be used to clean the outlet grille of the fan heater. Water Tank 1. Remove water tank, as described earlier, put into sink and empty water. 2.
Additional Information After Sales Service Your product is guaranteed for one year from the date of purchase. Within this period, we undertake to repair or exchange this product free of charge (excluding transducer discs & subject to availability) provided it has been installed and operated in accordance with these instructions. Your rights under this guarantee are additional to your statutory rights, which in turn are not affected by this guarantee.
Fig. 1a 305mm 570mm 440mm Fig. 1b 326mm Fig.
Fig. 3 Fig. 4 Fig. 5 Fig.
Fig. 7 Fig. 8 B A Fig. 9 Fig.
