Instruction Manual

7
Wall Control Installation
!
NOTE: All electrical wiring
must comply with all national
and local electrical codes
and regulations. Always
use a qualied and licensed
electrician should you have
any questions or concerns for
all wiring work.
!
NOTE: The Wall Switch
Remote Control is made
to t standard Decora
style faceplates. Due to
material inconsistencies of
individual faceplates, it may
be necessary to remove the
faceplate for operations such
as changing batteries.
Site Selection for
Installation
Although this Wall Switch Remote
Control can operate on battery
power or by hard wire installation,
a convenient and accessible
location should be chosen. The
range of the Wall Switch Remote
Control is approximately 50 feet
(15 m).
Installation requires the use of a
standard device box and should
the hard wire installation method
be chosen, a location near an
available 24V~ power source
should be considered.
WARNING: Electrocution or
other bodily harm and property
damage can occur if a live
wire is touched or damaged
during installation. Always
consult electrical schematics
for the installation location of
all wiring or consult a qualied
and licensed electrician before
you begin.
Installation
Required Tools and Hardware:
Flat head screwdriver•
Wire cutters / strippers•
Two (2) wire nuts for 22 AWG •
wire
Standard wall device box with •
minimum depth of 2.5 inches
(6.35 cm)
24V~ Power supply (for hard •
wired power installation if
applicable)
Battery Powered Installation
1. Remove the Wall Switch
Remote Control and
installation hardware from its
package.