Instruction Manual

5
Receiver Installation (BF units only)
Open steel curtain (remove 1.
glass doors if applicable).
Remove two (2) screws on log 2.
grate and remove log grate
(Figure 1).
Locate and remove the two (2) 4.
screws on the manual control
bracket (Figure 3). Remove
the bracket.
Locate and depress the 5.
mounting tabs on the plug
connector and remove the
manual control bracket from
replace (Figure 3).
Figure 1
Manual Controls
Screws
Pull front edge of plastic 3.
ember bed grate up and
forward until rear tab releases
from the ledge located at
the bottom of the partially
reective glass (Figure 2).
!
NOTE: Log set ts tightly into
rebox, some force may be
necessary to remove.
Figure 2
Back
ledge
Log
ember
bed
Rear
tab
Front
edge
Side section
Figure 3
Mounting
tabs
Plug
connector
Manual controls
Screw locations