Instruction Manual

4 www.dimplex.com
Product Overview
The Wall Switch Remote Control
Kit is designed to work with
the following Dimplex electric
replaces:
BF33STP •
BF33DXP •
BF39STP •
BF39DXP •
BF45DXP •
BFSL33•
BLF50 •
DF3033ST •
DFG3033BLK•
For the BF units, mentioned
above, follow the Remote
Receiver control installation
instructions starting on page 5.
For replace models BFSL33,
BLF50, DF3033ST and
DFG3033, the pre-installed
remote receiver in these models
is compatible with the Wall
Switch Remote Control. The
Remote Receiver and bracket
contained in this kit will not be
required, proceed directly to the
Wall Control Installation on page
7.
!
NOTE: This equipment has been
tested and found to comply with
the limits for Class B digital device,
pursuant to part 15 of the FCC Rules.
These limits are designed to provide
reasonable protection against harmful
interference in a residential installation.
This equipment generates, uses and
can radiate radio frequency energy
and, if not installed and used in
accordance with the instructions, may
cause harmful interference to radio
or television reception, which can be
determined by turning the equipment
off and on, the user is encouraged to
try to correct the interference by one or
more of the following measures:
· Reorient or relocate the receiving
antenna.
· Increase the separation between the
equipment and the receiver.
· Connect the equipment into an outlet
on a circuit different from that to which
the receiver is connected.
· Consult the dealer or an experienced
radio/TV technician for help.
Operation is subject to the following
two conditions: (1) this device may not
cause interference and; (2) this device
must accept any interference, including
interference that may cause undesired
operation of the device.