Instruction Manual

14 www.dimplex.com
Initialization
After installation, locate the
section which applies to your
specic model of replace and
follow the steps for remote control
initialization and if required,
re-initialization. Refer to your
replace's owner's manual to
locate manual or other controls as
needed.
BF Models Using the Included
Receiver Module
1. Ensure that power is supplied
through main service panel.
2. Inside the replace, locate the
toggle switch on the manual
controls and set to “Remote”
(Figure 17-C).
4. Press any button on the Wall
Switch Remote Control within
that 10 seconds.
BLF50 Models
1. Ensure that power is supplied
through main service panel.
2. Inside the replace, turn Main
On/Off Switch to Off
(Figure 18-A) and wait 10
seconds.
3. Move the Three Position
Switch (Figure 18-B) to the
“ REMOTE ” position.
Figure 17
A
B C
D
E F
3. Press and hold the On button
on the manual controls
(Figure 17-A) for ve (5)
seconds. The Level 1
Indicator Light (Figure 17-D)
will then ash for 10 seconds.
Figure 18
B A
BLF50 Manual controls
4. Turn Main On/Off Switch to On.
5. Press and hold the Manual
Control Button marked “
I ” (Figure 18-C) for ve
(5) seconds. After ve (5)
seconds, there is a 10 second
window to press any button on
the remote control.
6. Press any button on the Wall
Switch Remote Control within
that 10 seconds.
C