Specifications

7211270100 Rev03 3
Automatic Charge Control Wiring
DCP2010 Charge Control Panel
Dimplex’s DCP2010 Automatic Charge Control Panel provides the intelligence for the system
and:
• can control up to 30 VFMQ storage heaters.
• can control up to 4 additional 30 Amp loads including the existing water heater, baseboard
heaters in non-living areas and any other loads on their own circuit.
• the panel is supplied with an external temperature sensor with a 2m (6.5 ft) connection cable
that can be extended to 30m (98 ft) by #16/2 wire.
• the external sensor allows the DCP2010 controller to automatically correct for the large
temperature fluctuations in spring and fall by external temperature averaging.
The following wiring diagram shows how the DCP2010 Charge Control Panel connects:
• to various Off-Peak control timing devices.
• up to 30 VFMQ storage heaters through the Z1, Z2 terminals, wired in parallel.
• Up to 4 auxiliary loads such as a water heater.