Technical data

SOLC220 - Free standing kit
Page 18 of 20
ST0117 – C 08/09
SOLAR
Step 3.3 Connections
- Coat in O-rings of the connection pipe
(5.1) with the grease (5.5).
- Position the insert rings (5.6) in the 4th
and 5th trough of the corrugated pipe,
counted from the end.
- Next insert the connection pipe into the
collector connection until the outer in-
sert ring is flush with the outside of the
collector tulip.
Step 3.4 Connections
- Pull clamps (5.3) over collector connec-
tions and outer insert ring, using pliers
or an adjustable spanner press the
clamp closed so the screw secures it.
- Make sure the outer insert ring is cov-
ered by clamp.
Step 3.5 Connections
- Coat the o-rings on the end piece (5.2)
with grease (5.5).
- Insert the end piece tightly into the
collector connection.
- Next pull the clamp (5.3) over collector
connections and outer insert rings.
- Press the clamp with pliers or an ad-
justable spanner so the screw secures
the clamp in position.