Technical data

SOLC220 - Free standing kit
Page 14 of 20
ST0117 – C 08/09
SOLAR
Step 2.7 Collector
The above step (Step 2.7) gives an overview of the collector fixings and connections.
The highlighted areas (1, 2, 3 and 4) are presented in more detail below in the next
five steps.
Step 2.6 Collector
- Have the M10 hexagonal bolts (3.6),
large spacer sleeves (3.9), spring
washers (3.7) and M10 hexagonal nuts
(3.8) ready for fastening the collector.
- If laying the collector on the surface
for a short time, it may be necessary
to use an underlay to avoid damage to
the frame.
- The help of a second person is required
to position the collector and fix it in
place.
The collector must NOT be rested on
the back pane or the glass. It must
always be supported on the frame!