Technical data

SOLC220 - Free standing kit
Page 11 of 20
ST0117 – C 08/09
SOLAR
Step 1.3 Fixing
- Use the rawlplugs (3.4) and fasten
the U-pieces (3.1) with washers (3.3)
and bolts (3.2).
- If U-rails are being used, also fasten
these with washers (3.3) and bolts
(3.2).
Step 1.4 Fixing
- Attach the supporting tube (2) to the
rear U-pieces (3.1) with an M10 hex-
agonal bolt (3.6), spring washer (3.7)
and hexagonal nut (3.8).
- Put the protective cap (3.5) on the
supporting tube.
- Screw the bolt tight enough so that the
supporting tubes can be mounted up-
right.
Step 2.1 Collector
- Lift two of the square nuts in the slot
on the back of the collector (1) with
a screwdriver and hold them with the
installation aid (4.4).
- Using the installation aid, the nut can
easily be positioned for further instal-
lation of the T-pieces when the col-
lector (1) has been erected.