Sole/WasserWärmepumpe für Innenaufstellung Installation and Operating Instructions English Instructions d’installation et d’utilisation Français Montage- und Gebrauchsanweisung Brine-to-Water Heat Pump for Indoor Installation Bestell-Nr. / Order no. / No de commande : 452232.66.
Table of contents 1 Please Read Immediately .............................................................................................................E-2 1.1 Important Information.............................................................................................................................. E-2 1.2 Legal Regulations and Directives ........................................................................................................... E-2 1.3 Energy-Efficient Use of the Heat Pump .......
1 1 Please Read Immediately 1.1 Important Information ATTENTION! The heat pump is not secured to the wooden pallet. ATTENTION! The heat pump must not be tilted more than 45° (in any direction). English ATTENTION! Do not use the holes in the panel assemblies for lifting the device! ATTENTION! Flush the heating system prior to connecting the heat pump.
3 2.1 Purpose of the Heat Pump Application The brine-to-water heat pump is designed for use in existing or newly built heating systems. Brine is used as the heat carrier in the heat source system. Borehole heat exchangers, ground heat collectors or similar systems can be used as the heat source. 2.2 Operating Principle The heat generated by the sun, wind and rain is stored in the ground.
4 4 Accessories 4.1 Brine Circuit Manifold The brine circuit manifold merges the individual collector loops of the heat source system into a single main pipe which is connected to the heat pump. Integrated ball valves allow the individual brine circuits to be shut off for de-aeration purposes. 6 6.1 Set-up General Information The unit may only be installed indoors in rooms with low humidity on a level, smooth and horizontal surface.
7.4 Installation 7.1 General Information The following connections need to be established on the heat pump: Flow and return flow of the brine system Flow and return flow of the heating system Power supply 7.2 Heating System Connection ATTENTION! Flush the heating system prior to connecting the heat pump. Before connecting the heating water system to the heat pump, the heating system must be flushed to remove any impurities, residue from sealants, etc.
8 8 Commissioning 8.3 Start-up Procedure The heat pump is started up via the heat pump controller. 8.1 General Information To ensure that start-up is performed correctly, it should only be carried out by an after-sales service technician authorised by the manufacturer. This may be a condition for extending the guarantee (see Warranty). 8.2 Preparation The following items need to be checked prior to start-up: English The heat pump must be fully connected, as described in Chapter 7.
11 Maintenance and Cleaning 9.1 Maintenance The heat pump is maintenance-free. To prevent faults due to sediment in the heat exchangers, care must be taken to ensure that no impurities can enter either the heat source system or the heating system. In the event that operating malfunctions due to contamination occur nevertheless, the system should be cleaned as described below. 9.
12 12 Device Information Device information for brine-to-water heat pumps for heating purposes SI 5TE - SI 11TE 1 Type and order code SI 5TE 2 Design 2.1 Degree of protection according to EN 60 529 2.2 Installation Location 3 Performance data 3.1 Operating temperature limits: English Heating water flow °C Brine (heat source) °C Antifreeze Temperature spread of heating water (flow/return flow) at B0 / W35 3.3 Heat output / COP 3.
12 Device information for brine-to-water heat pumps for heating purposes SI 14TE - SI 21TE Type and order code SI 14TE 2 Design 2.1 Degree of protection according to EN 60 529 2.2 Installation Location 3 Performance data 3.1 Operating temperature limits: Heating water flow °C Brine (heat source) °C Antifreeze 3.
Anhang / Appendix / Annexes 1 Maßbilder / Dimension Drawings / Schémas cotés................................................................... A-II 1.1 Maßbild / Dimension Drawing / Schéma coté SI 5TE - SI 17TE............................................................. A-II 1.2 Maßbild / Dimension Drawing / Schéma coté SI 21TE.......................................................................... A-III Diagramme / Diagrams / Diagrammes ................................................................
1 1 Maßbilder / Dimension Drawings / Schémas cotés 1.
1.2 Maßbild / Dimension Drawing / Schéma coté SI 21TE Anhang · Appendix · Annexes FD DSSUR[ HQY 1.
2 2 Diagramme / Diagrams / Diagrammes 2.
2.2 2.
2.3 2.
2.4 2.
2.5 2.
2.6 2.
2.7 2.
3.1 3 Stromlaufpläne / Circuit Diagrams / Schémas électriques Steuerung / Control / Commande SI 5TE - SI 17TE 1HW] Â 0DLQV Â 5pVHDX Anhang · Appendix · Annexes 3.1 www.dimplex.
A-XII %DXVHLWV EHL %HGDUI DQ]XVFKOLHHQ 0XVW EH VXSSOLHG E\ FXVWRPHU WR EH FRQQHFWHG DV UHTXLUHG $ UDFFRUGHU VL EHVRLQ HVW SDU OH SURSULpWDLUH :HUNVVHLWLJ YHUGUDKWHW :LUHG IRU XVH &kEOp HQ XVLQH 9RU GHP (LQNOHPPHQ GHV 0 0RWRUVFKXW]HV GLH 'UDKWEUFNH $ HQWIHUQHQ $ LVW GLH %UFNH ³6W|UXQJ 0 ´ 7KH ZLUH MXPSHU $ PXVW EH UHPRYHG EHIRUH FRQQHFWLQJ WKH 0 PRWRU SURWHFWLRQ $ LV WKH ³0 IDXOW´ MXPSHU 5HWLUHU OH FDYDOLHU $ DYDQW GH UDFFRUGHU OD SURWHFWLRQ PRWHXU 0 $ HVW OH SRQW © 3DQQH 0 ª
1HW] Â 0DLQV Â 5pVHDX RGHU Â RU Â RX www.dimplex.de qPH HQWUpH GH FRXSXUH &RQWDFW RXYHUW 3$& EORTXpH 5HWLUHU OH SRQW $ VL QpFHVVDLUH QG GLVDEOH LQSXW &RQWDFW RSHQ +3 GLVDEOHG %ULGJH $ FDQ EH UHPRYHG DFFRUGLQJ WR QHHG Anhang · Appendix · Annexes 3RVVLELOLWp GH VpOHFWLRQHHU OD IRQFWLRQ GH ( 7KH IXQFWLRQ RI ( FDQ EH VHOHFWHG 'LH )XQNWLRQ YRQ ( LVW ZlKOEDU WHU 6SHUUHLQJDQJ .
3.4 3.4 A1 A2 A3 A4 B2* B3* B4* E9* E10* F2 F3 Anhang · Appendix · Annexes F4 F5 F15 H5* J1...
3.5 Steuerung / Control / Commande SI 21TE Anhang · Appendix · Annexes 3.5 www.dimplex.
3.6 3.
3.7 Klemmenanschlussplan / Terminal Connection Plan / Schéma de connexion des bornes SI 21TE Anhang · Appendix · Annexes 3.7 RGHU Â RU Â RX +HL]VWDE Â ,PPHUVLRQ KHDWHU Â 7KHUPRSORQJHXU www.dimplex.
3.8 3.8 A1 A2 B2* B3* B4* E9* E10* F2 F3 F4 F5 F12 F14 H5* J1...J18 K1 K5 K1.1 K1.
4.1 4 Hydraulisches Prinzipschema / Hydraulic Plumbing Diagram / Schéma hydraulique Darstellung / Schematic View / Représentation Anhang · Appendix · Annexes 4.1 www.dimplex.
4.2 4.
5 Anhang · Appendix · Annexes 5 Konformitätserklärung / Declaration of Conformity / Déclaration de conformité www.dimplex.
Glen Dimplex Deutschland GmbH Geschäftsbereich Dimplex Am Goldenen Feld 18 D-95326 Kulmbach Irrtümer und Änderungen vorbehalten. Subject to alterations and errors. Sous réserve d’erreurs et modifications. +49 (0) 9221 709 565 www.dimplex.
