OPTIMYST STOVE RTOPSTV20 08/51708/0 Issue 4 The product complies with the European Safety Standards EN60335-2-30 and the European Standard Electromagnetic Compatibility (EMC) EN55014, EN60555-2 and EN60555-3 These cover the essential requirements of EEC Directives 2006/95/EC and 2004/108/EC
Fig. 1 300 480 250 620 450 Fig. 2 Fig. 3 Fig. 4 Fig.
Fig. 5 Fig. 5a Fig. 5b Fig. 6 Fig. 7 Fig.
Fig. 9 Fig. 10 Fig. 11 Fig. 12 Fig. 13 Fig.
Fig. 15 Fig. 16 Fig.
Dimplex OPTIMYST Stove Introduction Thank you for choosing this Dimplex electric fire. Please read this information guide carefully to be able to safely install, use and maintain your product. Important Safety Advice When using electrical appliances, basic precautions should always be followed to reduce the risk of fire, electrical shock and injury to persons, including the following: 1. OVERHEATING WARNING: In order to avoid overheating, do not cover the heater.
Installation Instructions This section describes how to set up your fire. Before installing this appliance in an existing chimney, we recommend that; 1. You have your chimney cleaned by a competent chimney sweep. 2. You block off the chimney flue. This procedure is important for the efficient operation of the heating unit and will also reduce heat loss up the chimney. BEFORE YOU START 1.
Control Knob ‘D’:- Controls the intensity of the flame effect. Turning the control knob to the left increases the flame effect, turning the control knob to the right will decrease the flame effect. SETTING THE THERMOSTAT Ensure the fire is plugged in and switch it on to the full heat setting. Turn the Control Knob ‘C’ fully to the right (max temperature setting) to warm the room rapidly.
5. Fill tank with filtered tap water only. This is necessary to prolong the life of the flame and smoke producing unit. The water should be filtered through a conventional domestic water filter unit and the filter should be replaced regularly. 6. Screw the cap back on, do not over tighten. 7. Return the tank to the sump, with the tank cap facing down and the flat side of the tank facing outward. (Fig 8) 8. Gently place the fuelbed back into position. (Fig 9) 9.
Additional Information AFTER SALES SERVICE 1 Year Parts and Labour Your product is automatically guaranteed for one year from the date of purchase. Within this period, we undertake to repair or exchange this product free of charge providing: a) Proof of purchase such as a sales receipt can be provided, showing that the appliance was bought within the 12months prior to registering the defect/fault.
PATENT / PATENT APPLICATION Products within the Optimyst range are protected by one or more of the following patents and patent applications: Great Britain GB 2402206, GB 2460259, GB 2460453 , GB 2418014, GB 2465738, GB 2449925, GB 2465537 , GB 2455277 , GB1020534.2, GB1020537.5, GB1110987.3 United States US 7967690, US 2010299980, US 2011062250, US 2008028648, US 13/167,042 Russia RU2008140317 European EP 2029941, EP 2201301, EP 2315976, EP 1787063, EP07723217.1 , EP11170434.2, EP 11170435.
OPTIMYST is a trade mark of GDC Group Ltd. GDC Group Ltd. MILLBROOK HOUSE GRANGE DRIVE HEDGE END SOUTHAMPTON TEL: 0845 600 5111 FAX: 01489 773050 WEBSITE: www.dimplex.co.uk Republic of Ireland Tel. 01 8424833 SO30 2DF c GDC Group Ltd, All rights reserved. Material contained in this publication may not be reproduced in whole or in part, without prior permission in writing of Dimplex. A division of GDC Group Ltd.
