How to Guide

19
Operation
Icon Function Description
E
Color
Themes
Press multiple times to change the flame base colors
from Red to Blue to Off. (The first segment on the
display will change from "r" to "b" to blank) This
feature is active only when the flame effect is On.
F
360
°
Light
Press multiple times to change the LEDs on the sides
and back of the unit from Midnight mode to white to
yellow to red. (The middle segment on the display
will change through 0 - 3 respectively. This feature is
active only when the Flame is ON.)
G
Brightness
Press to change the LED lights from High to Low.
(The last segment on the display will change from "H"
to "L") The Realog
®
LEDs remain On when the heater
is ON and the flame effect is Off.
!
NOTE: When the Light Sensor is activated, High and
Low ickering brightness settings are also available
(Flashing "H" and "L").
H
Flame
Press to light the log set and start the flame effect.
Press again to turn feature Off.
I
Light
Sensor
Press to activate the ambient light sensor (ALS ON).
Press again to turn the sensor off (ALS OFF).
!
NOTE: The light sensor will adjust the brightness of the
replace based on the ambient light in the room.
J
Timer
Press multiple times to change the sleeper timer in
0.5 hr increments from 0.5 hr to 8.0 hr before turning
off. The remaining time on the sleep timer displays.
Control Lock
Control Unlock
Hold both Temp– (
) and Brightness ( ) on the
touch panel controls for 2 seconds to disable the
manual controls.
Hold both Temp– (
) and Brightness ( ) on the
touch panel controls for 2 seconds to enable the
manual controls.