Service Manual

5
MAINTENANCE
General Maintenance
Inspect the built-in electric rebox regularly, depending
upon conditions, and at a minimum yearly intervals.
Remove dust and clean the logs, grate, and base as
required.
WARNING: Disconnect power and allow heater to cool
before attempting any maintenance or cleaning to reduce
the risk of re, electric shock, or injury.
CAUTION: Except for installation and cleaning
described in this manual, an authorized service
representative should perform any other servicing.
Clean Logs and Base
The built-in electric rebox set should not be operated with
an accumulation of dust or dirt on or in the rebox, as this
can cause a build up of heat and eventual damage.
Dust and vacuum the rebox as needed. Use a damp cloth
and a mild detergent to clean painted surfaces of the built-
in electric rebox. Never use abrasive cleaners.
CleanReectorScreen
The reector screen is cleaned in the factory during the
assembly operation. During shipment, installation, handling,
etc., the screen may collect dust particles; these can be
removed by dusting lightly with a clean dry cloth.
To remove ngerprints or other marks, clean the reector
screen damp cloth. Never use abrasive cleaners. Dry the
screen completely with a lint free cloth to prevent water
spots.
Remote Battery Replacement
To replace the battery:
1. Push down on the battery cover located on the back of
the remote control. Slide the battery cover open.
2. Install 3V (CR2032) Lithium battery in the battery
holder. The positive (+) side of the battery faces up.
3. Close the battery cover.
The old battery must be recycled or disposed of properly.
Check with your Local Authority or Retailer for recycling
advice in your area.
CAUTION: When transporting or storing the heater and cord,
keep in a dry place, free from excessive vibration and store so as
to avoid damage.