Service Manual
Table Of Contents
- Operation
- Maintenance
- Exploded Parts Diagram
- Replacement Parts List
- Wiring Diagram
- Log Set Assembly Replacement
- Flame Screen Replacement
- Ember LED Light Replacement
- Flame Base LED Replacement
- Back Log LED Replacement
- Flicker Motor Replacement
- Main Control Board Replacement
- Power Supply Replacement
- Blower Assembly Replacement
- Element Replacement
- Cutout Replacement
- Main Control Assembly Replacement
- Thermistor Replacement
- Top Front Lights Replacement
- Troubleshooting Guide
4 www.dimplex.com
Icon Function Description
Heat Enable
Heat Disable
Hold both Heat ( ) and Temp– ( ), on the unit, for 2 seconds. Temperature displays
on the screen.
Hold both Heat ( ) and Temp– ( ), on the unit, for 2 seconds, when temperature is
adjusted "---" displays on the screen.
E
Color
Themes
Press multiple times to change the ame base colors from Red to Blue to Off. (The rst
segment on the display will change from "r" to "b" to blank) This feature is active only
when the ame effect is On.
F
360
o
Light
Press multiple times to change the LEDs on the sides and back of the unit from Midnight
mode to white to yellow to red. (The middle segment on the display will change through
0 - 3 respectively. This feature is active only when the Flame is ON.)
G
Brightness
Press to change the LED lights from High to Low. (The last segment on the display will
change from "H" to "L") The Realog
TM
LEDs remain On when the heater is ON and the
ame effect is Off.
!
NOTE: When the Light Sensor is activated, High and Low ickering brightness
settings are also available (Flashing "H" and "L").
H
Flame
Press to light the log set and start the ame effect. Press again to turn feature Off.
I
Light
Sensor
Press to activate the ambient light sensor (ALS ON). Press again to turn the sensor off
(ALS OFF).
!
NOTE: The light sensor will adjust the brightness of the replace based on the
ambient light in the room.
J
Timer
Press multiple times to change the sleeper timer in 0.5 hr increments from 0.5 hr to 8.0 hr
before turning off. The remaining time on the sleep timer displays.
Control Lock
Control Unlock
Hold both Temp– ( ) and Brightness ( ), on the unit, for 2 seconds to disable the
manual controls.
Hold both Temp– ( ) and Brightness ( ), on the unit, for 2 seconds to enable the
manual controls.
Resetting the Temperature Cutoff Switch
Should the heater overheat, an automatic cut out will turn the heater off and it will not come back on without being reset. It
can be reset by disconnecting power at the main electrical panel and waiting 5 minutes before plugging the unit back in.
CAUTION: If you need to con tinuously reset the heater, unplug the unit and call technical support at 1-888-346-7539.