Operating instructions

- 7 -

Fig. 6

Fig. 7

6. Place the heater in its ﬁ nal position and mark

the ﬁ xing holes through the location holes visible

through the back of the heater.

Mark the ﬁ xing positions at the two extreme ends of the

heater with the heater pushed tight against the wall.

Remove the wall bracket from the heater by removing

the two screws at each end of the bracket. Place

the heater to one side and reposition the bracket

against the wall aligning it with the location marks. It is

advisable to use a screwdriver with a magnetic tip

as screws dropped may enter the fan housing.

7. Six ﬁ xing positions must be selected for each

model. Mark the positions for the ﬁ xing holes.

Remove the bracket from the wall, drill the holes

and ﬁ t the wall ﬁ xings best suited to the application.

Secure the wall bracket to the wall using six screws.

Secure the heater using the appropriate screw ﬁ ttings.

NOTE: UNDER NO CIRCUMSTANCES SHOULD

ANY SCREWS BE REMOVED WITHOUT FIRST

REMOVING ALL BRICKS FROM THE HEATER.

QM070

QM100

QM125

QM150