Operating instructions

- 4 -

Preparation

1. Place the heater ﬂ at on the ground with arrows

printed on the base of the carton pointing upwards.

Open the carton at the bottom, slide the heater out

of the carton by at least 200mm exposing the feet

and the ﬁ xing kit located within the packaging on

the right hand side. Remove the feet and the ﬁ xing

kit.

2. Secure the feet to the heater. For models QM070

and QM100 two locations are possible indicated by

X and Y markings visible on the base of the heater.

Ensure the feet are ! xed at the location holes

marked with an ‘X’, see Fig. 2.

However, if this is a replacement heater check the

pitch of the feet and choose the appropiate ﬁ xing

positions - either X or Y.

Note - Foot screws are in the ! xing kit.

Stand the heater on its feet before removing the

packaging.

Dispose of the packaging in an appropriate way.

Read these instructions carefully before

proceeding any further with the installation.

Fig. 1

Fig. 2