Operating instructions

- 13 -

Fig. 17

17. Close the core by reﬁ tting the inner front panel

complete with insulation.

Ensure the bottom edge is located inside the

chassis and that the screws are tightly secured

down each edge.

IMPORTANT

Double check all mains connections are secure and

excess cable is restrained and not in contact with

any of the heater casing.

ON NO ACCOUNT SHOULD ANY SURPLUS

CABLE BE PUSHED INSIDE OR BEHIND THE

HEATER.

Once installed DO NOT attempt to reposition the

heater without ﬁ rst unloading the bricks.

Reassembly

To replace all the panels of the outer casing reverse

steps 3 - 5 of these instructions under the section

headed Preparation.

Ensure all ﬁ xings are secure.