Instructions / Assembly

9
Placement
This replace can be fully recessed into a wall with 2x4 framing or mounted on the wall.
!
NOTE: It is recommended that the bottom of the unit be mounted between 20" (51 cm) and 40" (102 cm) from
the ground to maintain an optimized viewing angle of the ame.
WARNING: The top of the replace must be installed a minimum of 24" (61 cm) from the ceiling.
The replace must be installed a minimum of 5" (13 cm) from the ground
Installation in a Bathroom
If this unit is installed in a bathroom it must be protected by a GFCI receptacle or circuit. If a receptacle is used it
must be readily accessible.
This electrical appliance is NOT watertight. To prevent electric shock, it must be installed as to prevent water from
entering the unit, or installed away from showers, tubs, etc. Never locate replace where it may fall into a bathtub or
other water container.
Wi-Fi
For installations where the use of the Flame Connect app is desired, ensure the replace is located within range of a
Wi-Fi network. For up to date information about the app, please visit www.dimplex.com/fcapp
Installation Recommendations for Overhanging Objects
For overhanging temperature-sensitive objects, such as a television, a mantel, or artwork, always follow the
recommendations provided by its manufacturer for installation over a heater.
!
NOTE: Using normal heat mode, surfaces 7” (18cm) above the replace will not exceed 40° C, as long as
installation procedures are followed and heater inlet and outlet are not obstructed.
Installation