Instructions / Assembly

17
Flame Speed
Press
repeatedly to cycle through the 5 ame speeds.
Heat
Press
to turn the heat on or off. The replace will beep once and the icon will
remain on the display when activated.
The replace can be operated in heat only mode by turning off the ame and color
effects.
Heat Disable
Press and hold the
and the at the same time for 3 seconds to disable or enable
the heat function. This action must be performed on the hidden touch controls.
When the heat is disabled and either the
, , or is pressed, --- will appear on the
display.
Temperature
Increase
Press
to decrease the temperature setting.
Temperature
Decrease
Press
to increase the temperature setting.
The temperature can be set from 7 °C to 30 °C (45 °F to 86 °F).
When the temperature setting is adjusted, the set temperature will ash for 2 seconds,
then the ambient room temperature will be displayed briey.
Temperature
Display
(°C ↔ °F)
Press and hold the and the at the same time for 3 seconds. This action must be
performed on the hidden touch controls.
Brightness
Press
repeatedly to cycle through the brightness and icker modes.
Solid L - Low Brightness
Solid H - High Brightness
Cycle L - Low Brightness with ickering media bed lights
Cycle H - High Brightness with ickering media bed lights
Ambient Light
Sensor
Press
to turn the ambient light sensor on or off.
The ambient light sensor will automatically adjust the brightness of the replace lights
based on the ambient light in the room.
Timer
Press
repeatedly until the desired number of hours of the timer is displayed. When
this function is active, the replace will turn off after a set amount of time. The timer
can be set from 30 minutes (display will show .5) to 8 hours in intervals of 30 minutes.
To turn the timer off, press repeatedly until 0 appears on the display.
While the timer is active, press the timer button to see the time remaining.
Moods
Press
repeatedly to cycle through the 8 different Moods, which will change the
colour of the media bed lighting.
1 - White
2 - Blue
3 - Violet
4 - Red
5 - Green
6 - Prism — media cycles through colors
7 - Prism — media cycles through colors at a faster speed
8 - Midnight mode — media bed lighting is off
Custom Color
Freeze the media bed lights to a custom color.
When in one of the Prism modes (see Moods), press while the desired color is
displayed to freeze the cycle on that color.
Press again to resume the color cycle.
Operation