Instructions / Assembly

11
Wall bracket anges inserted in slots
Installation
9. Drive 4 screws through the mounting holes located
on the inside sides of the rebox into the surrounding
frame. (Figure 6)
CAUTION: Ensure the air intake and heater exhaust
are not obstructed in installation. These are located
behind the front grill.
10. Follow the instructions for installing the mirrored glass,
media bed, and front glass (pp. 14-15).
Figure 6
Wall-mounted Installation
1. If using the optional power cord accessory
(PLFXSPLUG, sold separately), install it following the
instructions in the wiring section (p.13).
2. Remove the 3 screws that secure the electrical cover
to complete the wiring. (Figure 5)
3. Complete the wiring according to instructions in the
Electrical Installation section (pp. 12-13). Reinstall the
electrical cover after wiring is complete.
4. Position mounting bracket in desired location on the
wall and ensure that it is level using the provided
bubble level.
5. Use 2 of the provided mounting screws to attach the
mounting bracket onto wall. The mounting screws
must be inserted into wall studs.
6. Lift the replace onto the mounting bracket. (Figure8)
The anges from the mounting bracket should be
inserted into the slots on the back of the replace.
(Figure 9)
7. Follow the instructions for installing the mirrored glass,
media bed, and front glass (pp. 14-15).
Figure 7
Figure 8
Figure 9