Service Manual
Table Of Contents
- Operation
- Maintenance
- Exploded Parts Diagram - PF2325 Mod 0-A
- Exploded Parts Diagram - PF2325 Mod B
- Exploded Parts Diagram - PF3033 Mod 0-A
- Exploded Parts Diagram - PF3033 Mod B
- Wiring Diagram
- Main Control Board ReplacemenT (Mod 0-A units Only)
- Flame LED Light and Media Light Assembly Replacement
- Floating Display Assembly / Main Control Board Replacement
- Top Light Replacement
- Heater Assembly Replacement
- Power Cord Replacement
- Flicker Motor & Rod Replacement
- gWaveTM Assembly Replacement
- Relay Board Replacement (Mod B units Only)
- Power Supply Replacement (Mod B units Only)
- Log set Replacement
- Electronics Junction Board Replacement
- Lower & Media LED Light Assembly Replacement
- Partially Reflective Glass Replacement
- Power Regulator Board Installation (Mod 0 units Only)
- Troubleshooting Guide
12 www.dimplex.com
MAIN CONTROL BOARD REPLACEMENT
(Mod 0-A units Only)
Tools Required: Phillips Head Screwdriver
Flat Head Screwdriver
Needle Nose Pliers
CAUTION: If unit was operating prior to servicing allow
at least 10 minutes for heating elements and top panel to
cool off to avoid accidental burning of skin.
WARNING: Disconnect power before attempting any
maintenance to reduce the risk of electric shock or damage
to persons.
1. Unplug the unit from power outlet.
2. Remove the rebox from the front of the mantel and
remove front glass assembly (glass lifts off).
CAUTION: Even though the glass is safety glass it
may break if bumped, struck of dropped. Care must be
taken when handling the glass.
3. Remove the loose media from the unit (if applicable).
4. Remove the 14 screws around the back panel of the
rebox and the 3 along the middle of the panel (Figure
3).
5. Locate the main control board and transfer the wir-
ing connections from the old board to the new board.
(Figure 4)
!
NOTE: A at head screwdriver can be used to gently
pry between the end of the connector and the main control
board to release the wires.
6. Release the main control board from the unit by using
needle nose pliers to depress the tab on the mounting
standoffs and gently lift the driver board off.
7. Properly orient and insert the new main control board.
8. Reassemble in the reverse order as above.
Figure 3
FLAME LED LIGHT AND MEDIA LIGHT
ASSEMBLY REPLACEMENT
Tools Required: Phillips Head Screwdriver
Small Adjustable Wrench
CAUTION: If unit was operating prior to servicing allow
at least 10 minutes for heating elements and top panel to
cool off to avoid accidental burning of skin.
WARNING: Disconnect power before attempting any
maintenance to reduce the risk of electric shock or damage
to persons.
1. Unplug the unit from power outlet.
2. Remove the rebox from the front of the mantel and
remove front glass assembly (glass lifts off).
CAUTION: Even though the glass is safety glass it
may break if bumped, struck of dropped. Care must be
taken when handling the glass.
Figure 4
gWave
TM
Assembly
Flicker Motor
Main Control Board
Floating Display
Assembly
Heater Assembly
Top LED Light
Flame LED Light Assembly
Back Panel
Top Panel
Mod B
Mod 0-A
gWave
TM
Assembly
Flicker Motor
Relay Board
Floating Display
Assembly
Heater Assembly
Top LED Light
Media LED Light Assembly
Power Board