OAKHURST OKT20 08/51861/0 Issue 3 The product complies with the European Safety Standards EN60335-2-30 and the European Standard Electromagnetic Compatibility (EMC) EN55014, EN60555-2 and EN60555-3 These cover the essential requirements of EEC Directives 2006/95/EC and 2004/108/EC
Fig. 1 480 250 620 250 300 Fig. 2 Fig. 3 Fig. 4 Fig.
Fig. 5 Fig. 5a Fig. 5b Fig. 6 Fig. 7 Fig.
Fig. 9 Fig. 10 Fig. 11 Fig. 12 Fig. 13 Fig.
Fig. 15 Fig. 16 Fig.
Dimplex OPTIMYST Stove Introduction Thank you for choosing this Dimplex electric fire. Please read this information guide carefully to be able to safely install, use and maintain your product. Important Safety Advice When using electrical appliances, basic precautions should always be followed to reduce the risk of fire, electrical shock and injury to persons, including the following: 1. OVERHEATING WARNING: In order to avoid overheating, do not cover the heater.
Installation Instructions This section describes how to set up your fire. Before installing this appliance in an existing chimney, we recommend that; 1. You have your chimney cleaned by a competent chimney sweep. 2. You block off the chimney flue. This procedure is important for the efficient operation of the heating unit and will also reduce heat loss up the chimney. BEFORE YOU START 1.
Control Knob ‘D’:- Controls the intensity of the flame effect. Turning the control knob to the left increases the flame effect, turning the control knob to the right will decrease the flame effect. SETTING THE THERMOSTAT Ensure the fire is plugged in and switch it on to the full heat setting. Turn the Control Knob ‘C’ fully to the right (max temperature setting) to warm the room rapidly.
5. Fill tank with filtered tap water only. This is necessary to prolong the life of the flame and smoke producing unit. The water should be filtered through a conventional domestic water filter unit and the filter should be replaced regularly. 6. Screw the cap back on, do not over tighten. 7. Return the tank to the sump, with the tank cap facing down and the flat side of the tank facing outward. (Fig 8) 8. Gently place the fuelbed back into position. (Fig 9) 9.
Additional Information AFTER SALES SERVICE Your product is guaranteed for two year from the date of purchase. Within this period, we undertake to repair or exchange this product free of charge (excluding lamps & subject to availability) provided it has been installed and operated in accordance with these instructions. Your rights under this guarantee are additional to your statutory rights, which in turn are not affected by this guarantee.
Troubleshooting Symptom Cause Corrective Action The flame effect will not start. Mains plug is not plugged in. Check plug is connected to wall socket correctly. Low water level. Low voltage connector not connected properly. (See Fig.5) Check that the water tank is full and there is water in the sump. Check that the connector is inserted correctly. (See Fig.
GLEN DIMPLEX PRODUCT WARRANTY This warranty is provided by Glen Dimplex Australia Pty Limited ABN 69 118 275 460 of Unit 1, 21 Lionel Road, Mount Waverley, Victoria 3149 (Phone number 1300 556 816), or in New Zealand by Glen Dimplex Australasia Limited, New Zealand registration number 1506305, of 38 Harris Road, East Tamaki, Auckland, New Zealand (Phone number 09 2748265) (we, us our) in respect of the Glen Dimplex product which this warranty card has been included in the packaging for or otherwise supplied
(c) the repair relates to the replacement of consumable parts such as fuses in plugs and bulbs or any other parts of the Glen Dimplex product which require routine replacement; (d) you are unable to provide us with reasonable proof of purchase for the Glen Dimplex product; (e) the breakdown occurs after the expiry of the express warranty period set out in section 1; or (f) the Glen Dimplex product was not purchased in Australia or New Zealand as a brand new product.
Glen Dimplex products are designed and supplied for normal domestic use. We will not be liable to you under this warranty for business loss or damage of any kind whatsoever. 6 Costs of warranty claim Where you make a claim under this warranty, a Glen Dimplex authorised repairer may need to attend your premises to inspect the Glen Dimplex product.
