Warranty

17
Maintenance
WARNING: Disconnect power
and allow heater to cool before
attempting any maintenance or
cleaning to reduce the risk of
re, electric shock or damage to
persons.
!
NOTE: The replace should not
be operated with an accumulation
of dust or dirt on or in the unit,
as this can cause a build up of
heat and eventual damage. For
this reason the heater must be
inspected regularly, depending
upon conditions and at least at
yearly intervals.
Partially Reective Glass
Cleaning
The partially reective glass is
cleaned in the factory during the
assembly operation. During shipment,
installation, handling, etc., the
partially reective glass may collect
dust particles; these can be removed
by dusting lightly with a clean dry
cloth.
To remove ngerprints or other
marks, the partially reective glass
can be cleaned with a damp cloth.
The partially reective glass should
be completely dried with a lint
free cloth to prevent water spots.
To prevent scratching, do not use
abrasive cleaners.
Fireplace Surface Cleaning
Use only a damp cloth to clean
painted surfaces of the replace. Do
not use abrasive cleaners.
Servicing
Except for installation and cleaning
described in this manual, an
authorized service representative
should perform any other servicing.