User`s guide

7
7. Unscrew bulbs counter clockwise.
8. Insert new bulbs.
9. Re-install upper light panel.
10. Slide front glass back into position and attach trim.
11. Re-insert the fi rebox. Please take care when placing fi rebox in mantel (2 person lift)
PURIFIRE™ FILTER
The Purifi re™ fi lter supplied in your fi rebox is reusable and washable. The fi lter should be cleaned or
replaced on average once a year. To clean the fi lter gently tap fi lter on a hard surface to dislodge any
loose dirt or debris, and then clean with water. No soap or cleaning products are recommended. The
fi lter size is 508mm x 254mm x 25mm (20inch X 10inch X 1inch) rated at MERV 10.
TO REPLACE FILTER (FIGURE 9)
1. Remove fi rebox from mantel.
Please take care when placing fi rebox in mantel (2 person lift)
2. Filter can be accessed from the top rear of the unit.
3. Grasp fi lter and slide fi lter straight up.
4. Replace or clean fi lter.
NOTE
If after market air fi lter is used ensure it is installed according to the manufacturers recommended
instructions.
FIGURE 9
Air Filter
Firebox
GLASS CLEANING
The glass is cleaned in the factory during the assembly operation. During shipment, installation, handling,
etc., the glass may collect dust particles. These can be removed by dusting lightly with a clean dry cloth.
To remove fi ngerprints or other marks, the glass can be cleaned with a damp cloth. To prevent scratch-
ing, do not use abrasive cleaners or spray liquids on the glass surface.
FIREBOX SURFACE CLEANING
Use a cloth dampened with warm water only to clean painted surfaces of the electric fi rebox. Do not use
abrasive cleaners.