Use and Care Manual

11
Flicker Motor Replacement
Tools Required: Phillips head screwdriver
Pliers
Side cutters
WARNING: If the rebox was operating prior to
servicing, allow at least 10 minutes for the heating
elements to cool o󰀨 to avoid accidental burning of skin.
WARNING: Disconnect power before attempting any
maintenance to reduce the risk of electric shock or injury to
persons.
1. Follow the instructions for accessing the bottom
components on pages 8-9.
2. Remove the right side icker rod retaining bracket by
unscrewing the two corresponding screws on the back
of the rebox. (Figure 5)
3. Pull the icker motor out from the rubber coupling
attached to the icker rod.
4. Remove the two screws that a󰀩x the icker motor to
the bracket.
5. Cut the ve wires as close as possible to the icker
motor.
6. Cut wire leads from the new icker motor to 3 1/2
inches long.
7. Using one of the supplied wire connectors, connect the
yellow wire from the new icker motor with the yellow
wire cut from the old icker motor.
8. Secure the wire connector by crimping the 3M symbol
with pliers. Pull on both wires to ensure a strong
connection.
9. Repeat the process for the 4 remaining wires, ensuring
that all wires are paired by colour in each connector.
10. Attach new icker motor to the retaining bracket.
11. Insert stem from icker rod into the rubber grommet.
12. Reattach the icker rod retaining bracket.
13. Reassemble the rebox.
Remove this bracket when
changing icker motor
Remove this bracket when
changing icker rod
Media bed/Log
set screws
Flame screen retaining
bracket screws
Heater assembly screws
Flicker Rod Replacement
Tools Required: Phillips head screwdriver
WARNING: If the rebox was operating prior to
servicing, allow at least 10 minutes for the heating
elements to cool o󰀨 to avoid accidental burning of skin.
WARNING: Disconnect power before attempting any
maintenance to reduce the risk of electric shock or injury to
persons.
1. Follow the instructions for accessing the bottom
components on pages 8-9.
2. Remove the left side icker rod retaining bracket by
unscrewing the two screws from the back of the rebox.
(Figure 5)
3. Pull the old icker rod out from the rubber grommet.
4. Insert new icker rod.
5. Place bracket over the end of the new icker rod and
rea󰀩x the bracket to the rebox.
6. Reassemble the rebox.
Figure 5