PRACTICAL USER’S GUIDE FOR THE CORNER WALL MOUNTED ELECTRIC FIREPLACE MODEL NUMBER: EWMC-CC-SS Quality checked by: Valued Customer, We are pleased that you have chosen to purchase an electric fireplace manufactured by Dimplex North America Limited.
CONTENTS PAGE 1 Important Instructions PAGE 2 Model and Serial Number Information PAGE 3 Wall Mount Installation PAGE 8 Operation PAGE 10 Maintenance PAGE 12 Warranty
QUICK REFERENCE GUIDE FOR THE ELECTRIC CORNER WALL MOUNT FIREPLACE 1. Before using the electric corner wall mounted fireplace verify: • Are the circuit breakers for the unit on? • Are the light bulbs loose? (to check, follow the instructions for replacing the light bulbs under the maintenance section of this manual) 2. The heater may emit a slight, harmless odor when first used. This odor is a normal condition caused by the initial heating of internal heater parts. 3.
IMPORTANT INSTRUCTIONS SAVE THESE INSTRUCTIONS RETAIN THIS USER’S GUIDE FOR FUTURE REFERENCE When using electrical appliances, basic precautions should always be followed to reduce the risk of fire, electric shock, and injury to persons. 1. Read all instructions before using the corner wall mounted electric fireplace. 2. The heater is hot when in use. To avoid burns, do not let bare skin touch hot surfaces. The trim around the heater outlet becomes hot during heater operation.
IMPORTANT INSTRUCTIONS If you have any questions about out products please have the product model and serial numbers available upon calling Dimplex customer service. To locate the model and serial number labels see below.
NOTE A 15amp, 120 volt circuit is required. A dedicated circuit is preferred but not essential in all cases. A dedicated circuit will be required if, after installation, the circuit breaker trips or the fuse blows on a regular basis when the heater is operating. Additional appliances on the same circuit may exceed the current rating of the circuit breaker. WARNING Placing heavy objects on top of this fireplace may cause damage or injury. Maximum suggested weight to be placed on top of unit is 25 lbs/11 kg.
4. To mount the unit so that the wall outlet is hidden, mount the bracket 30”- 33” above the top of the outlet. (FIGURE 3) 5. Use a stud locator to determine the location of the studs in the corner. 6. Mark the stud locations on the wall. 7. Position mounting brackets on wall and align with wall stud markings. NOTE Ensure that each mounting bracket is installed into at least one wall stud. NOTE When installing into one wall stud use one of the center locations as indicated in FIGURE 6.
FIGURE 6 FIGURE 7 5
UNIT INSTALLATION FIGURE 8 SECURING DECORATIVE TOP PANEL TO UNIT NOTE Secure decorative top panel to unit after installing unit to wall. NOTE Top panel brackets are left loose by the manufacturer in order to be adjusted to match the engaging holes in the back panel. TOOLS Slotted screwdriver 1. Place decorative top panel on top of unit. 2. Open door to achieve access to top panel brackets. 3. Align top panel brackets with holes on back panel. 4.
