Owner`s manual

7
Fireplace Installation
!
NOTE: A 15 Amp, 120 Volt
alternating current (VAC) circuit
is required. A dedicated circuit
is preferred but not essential in
all cases. A dedicated circuit will
be required if, after installation,
the circuit breaker trips or fuse
blows on a regular basis when the
heater is operating. Additional
appliances on the same circuit
may exceed the current rating of
the circuit breaker.
WARNING: Ensure the power
cord is not installed so that
it is pinched or against a
sharp edge and ensure that
the power cord is stored or
secured to avoid tripping or
snagging to reduce the risk of
re, electric shock or injury to
persons.
WARNING:Construction and
electrical outlet wiring must
comply with local building
codes and other applicable
regulations to reduce the risk
of re, electric shock and injury
to persons.
WARNING:Do not attempt to
wire your own new outlets or
circuits. To reduce the risk of
re, electric shock or injury
to persons, always use a
licensed electrician.
Make sure the unit’s 1.
3-Position Switch is switched
OFF ("O") (refer to operating
instruction section).
Plug the unit into a 15 2.
Amp/120 VAC outlet. If the
cord does not reach, you may
use an extension cord rated
for a minimum of 1875 Watts.