Owner`s manual

9
 WARNING: Disconnect
power before attempting any
maintenance or cleaning to
reduce the risk of re, electric
shock or damage to persons.
Helpful Hints
It is a good idea to replace all
light bulbs at one time if they are
close to the end of their rated life.
Group replacement will reduce
the number of times you need
to open the unit to replace light
bulbs.
Light Bulb Replacement
Allow at least ve (5) minutes for
Maintenance
the light bulbs to cool off before
touching to avoid accidental
burning of the skin. Light bulbs
needs to be replaced when you
notice a dark section of the ame
or when the clarity and detail of
the log exterior disappears.
There are two (2) bulbs located
under the Log Set which generate
the ames and embers.
Tools Required: Phillips
screwdriver
Light Bulb Requirements
Quantity of two (2) clear
chandelier or candelabra bulbs
Figure 2
Operation
Battery
Battery Cover
This will synchronize the remote
control transmitter and the
replace receiver.
!
NOTE: You will have only 10
seconds to perform this last
step. Failure to do so will result
in these steps needing to be
followed again.
Battery Replacement
To replace the battery:
Slide battery cover open on
the hand held transmitter
(Figure 2).
Correctly install one (1) 12
Volt (A23) battery in the
battery holder.
Close the battery cover.