Owner`s manual

10 www.dimplex.com
Operation
integrated on/off remote control.
!
NOTE: Ensure that the re-
place 3 position switch is set to
the remote control setting (up
position).
To operate, push the ON button
to turn replace on, push the OFF
button to turn the replace off.
!
NOTE: Before attempting any
operation with the remote, pull
the plastic insulator strip out
from between the remote cas-
ing and battery cover (Figure 3).
Remote Control Initialization/
Reprogramming
In the event that your remote
control ceases to operate your
replace, follow these steps to
re-initialize the remote control and
the remote control receiver in the
replace:
1. Place the 3-position switch
(Figure 2A) in the Off (“ O ”)
position.
2. Wait a minimum of ve sec-
onds and then place the
3-Position Switch in the Re-
mote Control (“ II ”) position.
3. Within 10 seconds of chang-
ing the switch position, press
the ON button located on the
remote control (Figure 2).
This will synchronize the remote
control and the replace receiver.
!
NOTE: You will have only 10
seconds to perform this last step.
Failure to do so will result in these
steps needing to be followed
again.
Battery Replacement
(Figure 3)
To replace the battery:
1. Slide battery cover open on
the remote control.
2. Correctly install one 12 Volt
(A23) battery in the battery
holder.
3. Close the battery cover.
Battery must be recycled
or disposed of properly.
Check with your Local
Authority or Retailer for recycling
advice in your area.