Owner`s manual

9
Maintenance
WARNING: Always
disconnect from the power
supply before attempting any
maintenance.
Bulb Replacement
The bulbs are located behind the
back panel.
To gain access to the bulbs:
Remove the silver screw that 1.
secures the access panel to
the rebox as indicated in
Figure 2.
Remove and slide out panel.2.
Remove the defective lamp 3.
by unscrewing it as shown in
Figure 3.
Replace with a 60 Watt 4.
E12 clear chandelier or
candelabra. Take care not to
over-tighten the bulb.
Ret the access panel 5.
and secure with the screw
removed in step 1.
!
NOTE: To remove the rebox
insert prior to repair, remove the
ve (5) black screws at the back
of the rebox as shown in Figure
2 and slide it out to the front.
Helpful Hints
It is a good idea to replace all
light bulbs at one time if they are
close to the end of their rated life.
Group replacement will reduce
the number of times you need
to open the unit to replace light
bulbs.
Cleaning
WARNING: Always
disconnect from the power
supply before cleaning the
replace.
For general cleaning use a
soft clean duster – never use
abrasive cleaners. The glass
viewing screen should be cleaned
carefully with a soft cloth. DO
NOT use glass cleaners.
To remove any accumulation
of dust or uff the soft brush
attachment of a vacuum cleaner
should occasionally be used to
clean the outlet grill of the fan
heater.