Owner`s manual

9
notice a dark section of the ame
or when the clarity and detail
of the log exterior disappears.
There is one (1) bulb located at
the back of the unit behind the
access panel.
Light Bulb Requirement
Quantity of one (1) clear
chandelier or candelabra bulb
with an E-12 (small) socket base,
and 60 Watt rating.
To Replace the Bulb (Figure 2)
① Remove the ve Phillips
screws from the access panel,
located on the back of the unit,
and remove access panel.
② Locate and examine the bulb
to determine if replacement is
required.
③ Unscrew the bulb counter
clockwise.
④ Insert and install new bulb.
⑤ Secure access panel to unit.
Clear Door Panel Cleaning
The clear door is cleaned in
the factory during the assembly
operation. During shipment,
installation, handling, etc., the
Maintenance
clear door may collect dust
particles. These can be removed
by dusting lightly with a clean, dry
cloth.
To remove ngerprints or other
marks, the clear doors can be
cleaned with a damp cloth. The
clear door should be completely
dried with a lint free cloth to
prevent water spots. To prevent
scratching, do not use abrasive
cleaners or spray liquids on the
clear door surface.
Sub-Compact Stove
Surface Cleaning
Use warm water only to clean
painted surfaces of the Sub-
Compact Stove. Do not use
abrasive cleaners.
Servicing
Except for light bulb replacement
and cleaning described
above, an authorized service
representative should perform
any other servicing.