INSTRUCTION MANUAL Oil Free Column Heaters Models: ECR15, ECR15FA, ECR15TIF, ECR24, ECR24FA & ECR24TIF For domestic household use only.
IMPORTANT THESE INSTRUCTIONS SHOULD BE READ CAREFULLY AND RETAINED FOR FUTURE REFERENCE. Note also the information presented on the appliance CAUTION: FAILURE TO FOLLOW THESE INSTRUCTIONS MAY CAUSE INJURY AND/ OR DAMAGE AND MAY INVALIDATE YOUR WARRANTY Please read the operating instructions carefully before using your product for the first time and keep them in a safe place.
IMPORTANT THESE INSTRUCTIONS SHOULD BE READ CAREFULLY AND RETAINED FOR FUTURE REFERENCE. Note also the information presented on the appliance • • • • To reduce the risk of fire, keep textiles, curtains and or flammable material a minimum distance of 1m from the air outlet. In order to avoid overheating, DO NOT COVER the appliance.
Exposed to the weather outdoors 4 Near water If the power cable wires are frayed or cut Where small children may be left unattended If an extension lead may become overloaded Where the power cable may be damaged On a slope or uneven surface Where there is risk of fire or close to a naked flame Where it may be damaged by chemicals Where there is a risk of interference by foreign objects This product is not made for DIY repair If there is a risk of water falling on the unit
Specifications Model no. ECR15 ECR15FA Power supply ECR15TIF ECR24 ECR24FA ECR24TIF 220-240V~, 50Hz Rated power 1500W 2400W Heat settings 3 3 3 3 3 3 Thermostat Y Y Y Y Y Y Timer N N Y N N Y Turbo Fan N Y Y N Y Y 8.1 kg 7.1 kg 7.2 kg 11.8 kg 10.7 kg 10.8 kg Weight (net) Dimensions (w x d x h) 415x280x635mm 320x280x635mm 320x280x635mm 585x280x635mm 505x280x635mm 505x280x635mm For greater precision, please always refer to the rating label placed on the product.
Fitting The Castors WARNING The radiator must only be operated with the wheels and castors fitted and in an upright position. The castors must be fitted to the control panel and on the bracket between the last and second last fin on the opposite end, as shown in Fig.1. 1. To fit the castors, turn the radiator upside down on a carpet or other soft surface to avoid damage Warning: The radiator is heavy – ensure that it is supported to prevent it from toppling.
Positioning Select the position for the heater ensuring there is clearance from any furniture and fittings of at least 300mm above the heater and 150mm each side and 300mm from the control and end panel. We recommend maximising the clearance where possible. NOTE: The radiator is designed for operation on an AC electricity supply, and is only suitable for domestic use and similar indoor locations. Tips • The radiator is fitted with castors and a handle for ease of movement.
Operation IMPORTANT - OBJECTS OR CLOTHING MUST NOT BE PLACED ON THIS HEATER. Before using the heater ensure that all warnings and instructions have been read carefully. To activate the heater simply plug it in. Neon indicator lights located at the control area will illuminate when the appliance is plugged into the mains. This indicates the appliance is energised and ready to use.
Operation Thermostat The Thermostat, see Fig.2 controls the heat output according to the room temperature. This ensures that the heater will not produce heat unnecessarily when the room is warm. 1. To set the temperature you require, turn the thermostat knob clockwise until the required setting is reached. Alternatively to heat a cold room quickly, turn the thermostat knob up fully. 2.
Timer model ELECTROMECHANICAL TIMER (Ti models) Fig. 4 Setting the time of day To set the time of day, rotate the timer dial clockwise (indicated by the arrow) until the correct time of day is opposite the reference mark - see Fig.4. The 24-hour clock is used; e.g. time shown for 4pm is '16' (16:00hrs). Operation Modes Set the operation mode using the slide switch on the timer - see Fig.5: Position I - Manual operation This setting allows power to the heater uninterrupted by the timer settings.
Setting the 'Auto' ON and OFF times To set the timer: 1. Using your finger tip or tip off a pencil, push in as many segments as necessary around the dial, according to the times you don't require heat - see Fig.5. Each segment pushed in switches the heater OFF for that part of the hour All other segments will be ON. For example, Fig.5 shows the timer set to switch the heater OFF between 11pm and 1.45am. 2. You can select as many ON periods as you like, within the 24-hour day.
Cleaning Over time, dust can accumulate on the heater which can effect performance. It is recommended to clean the unit at least once a month. 1. Turn the unit OFF and disconnect the appliance from the power supply. 2. Remove any dust build up with a soft brush. 3. Wipe the surface of the unit with a soft damp cloth. Mild detergent can be used for any stubborn marks. IMPORTANT The control panel and other parts must not come into contact with water or any other liquids.
Maintenance If the unit fails to operate efficiently, is broken or other problems arise, unplug and do not operate. Ask for advice by calling your local after sales service agent or the Customer Care Centre on 1300 556 816 (AU) / 0800 666 2824 (NZ). Warranty Please refer to the warranty card in the box for warranty information. For any troubleshooting advice, please contact the relative Customer Care Centre below.
Customer Care: 1300 556 816 customer.care@glendimplex.com.au www.dimplex.com.au Supplied by Glen Dimplex Australia 1340 Ferntree Gully Road, Scoresby, Victoria, 3179 © Glen Dimplex Australia. All rights reserved. Material contained in this publication may not be reproduced in whole or in part, without prior permission in writing of Glen Dimplex Australia.
